Specifications

03/12/17 CD-MPX870 01-13.fm
E-12
ENGLISH
CD-MPX870W
CD-MPX870
Preparation for Use
 Setting the FM/AM span selector
(CD-MPX870W only)
The International Telecommunication Union (ITU) has established
that member countries should maintain either a 100 kHz or a 50 kHz
interval between broadcasting frequencies of FM stations and 10
kHz or 9 kHz for AM station. The illustration shows the 50/9 kHz
zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, set the SPAN SELECTOR switch (on the rear
panel) to the interval (span) of your area.
To change the tuning zone:
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Set the SPAN SELECTOR switch (on the rear panel) as follows.
 For 50 kHz FM interval (9 kHz in AM) → 50/9
 For 100 kHz FM interval (10 kHz in AM) → 100/10
3 While pressing down the button and the button, press the
TUNER (BAND) button until "CLEAR ALL" appears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD program.
 Demonstration mode
 Outdoor FM antenna
Use an outdoor FM antenna if you require better reception. Consult
your dealer.
Note:
When an outdoor FM antenna is used, disconnect the supplied FM
antenna wire.
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll and the front
speaker will light up in flashing mode.
To cancel the demonstration mode:
When the unit is in the power
stand-by mode (demonstration
mode), press the X-BASS/DEMO
button. The demonstration mode
will be canceled and the display will
disappear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS /
DEMO button again.
Note:
When the power is on, the X-BASS/DEMO button can be used to se-
lect the extra bass mode.
Outdoor
FM antenna
75 ohms
coaxial cable
ANTENNA
FM
75 OHMS
AM
GND