User`s guide

AcuLaser M4000 Series User's Guide
Using the Control Panel 64
Page Protect
Allocates additional printer memory for printing data, as opposed to receiving it. You may need to
turn this setting on if you are printing a very complex page. If a Print Overrun error message
appears on the LCD panel during printing, turn this setting on and reprint your data. This reduces
the amount of memory reserved for processing data so your computer may take longer to send the
print job, but it will allow you to print complex jobs. Page Protect usually works best when Auto is
selected. You will need to increase your printer’s memory if memory errors continue to occur.
Note:
Changing the Page Protect setting reconfigures the printer’s memory, which causes any downloaded fonts to
be deleted.
Toner Alert
Specifies whether or not to display the alert when the imaging cartridge is near the end of its
service life.
If you select Set, the alert is displayed when the imaging cartridge is near the end of its service life.
Printing can be continued by pressing Start/Stop button.
If you select Skip, printing continues even if the imaging cartridge is near the end of its service life.
LCD Contrast
Adjusts the contrast of the LCD panel. Use the u Up and d Down buttons to set the contrast
between 0 (lowest contrast) and 15 (highest contrast.)
RAM Disk
Specifies the RAM disk size available for the Reserve Job function. See the table below for details.
Optional RAM capacity
(Total RAM capacity)
Size
Off Normal Maximum
64 MB (Total 128MB) Disabled n/2 MB
(n=Optional RAM
capacity)
64 MB
128 MB (Total 192MB) 128 MB
192 MB - 384 MB (Total 256 - 448 MB) 192 MB
512 MB (Total 576 MB) 320 MB