User`s guide

AcuLaser M4000 Series User's Guide
Using the Control Panel 61
Setup Menu
*1
Available only when the corresponding option is installed.
*2
Available only when you use A4, A5, B5, LT, HLT, LGL, EXE, GLG, GLT, or F4 size paper.
*3
Available only for ESC/Page, ESC/P2, FX, or I239X mode.
*4
Not available in PS 3 mode.
*5
After this setting is changed, the printer will automatically reboot and the new setting takes effect.
*6
After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again.
Language
Specifies the language displayed on the LCD panel and that printed on the status sheet.
Item Settings (default in bold)
Language English, Français, Deutsch, Italiano, ESPAÑOL, SVENSKA, Dansk, Nederlands,
SUOMI, Português, Norsk, , , , ,
Time to Sleep 5, 15, 30, 60, 120, 180, 240 Min
Time Out 0, 5 to 60 to 300 in increments of 1
Paper Source Auto, MP, Cassette 1, Cassette 2
*1
, Cassette 3
*1
Out Bin
*1
Face-down, Stacker
Stacker
*1
+Face-down, No Face-dwn
MP Mode Normal, Last
Manual Feed Off, 1st Page, EachPage
Copies 1 to 999
Duplex
*1 *2
Off, On
Binding
*1 *2
Long Edge, Short Edge
Start Page
*1 *2
Front, Back
Offset Stacking
*1
Off, On
Paper Type Normal, Thick, ExtraThk, Transparency
Skip Blank Page
*3
Off, On
Auto Eject Page
*4
Off, On
Size Ignore Off, On
Auto Cont Off, On
Page Protect
*3
Auto, On
Toner Alert Skip, Set
LCD Contrast 0 to 7 to 15
RAM Disk
*1 *6
Off, Normal, Maximum