User`s guide

AcuLaser M4000 Series User's Guide
Troubleshooting 167
Printing in the PostScript 3 Mode Problems
The problems listed in this section are those that you may encounter when printing with the
PostScript driver. All procedural instructions refer to the PostScript printer driver.
The printer does not print correctly in the PostScript mode
The printer does not print
Cause What to do
The printer’s emulation mode setting is incorrect. The printer is set to the Auto mode by default, so that it can
automatically determine the encoding used in the received
print job data and select the appropriate emulation mode.
However, there are situations where the printer cannot select
the correct emulation mode. In this case, it must be set
manually to PS3.
Set the emulation mode through the SelecType
Emulation Menu on the printer. See “Emulation Menu” on page
58.
The printer’s emulation mode setting for the interface
that you are using is incorrect.
The emulation mode can be set individually for each interface
which receives print job data. Set the emulation mode for the
interface you are using to PS3.
Set the emulation mode through the SelecType
Emulation Menu on the printer. See “Emulation Menu” on page
58.
Cause What to do
The Save as File check box is selected on the Output
Options sheet in the Print dialog box (Mac OS 10.2.x
and 10.3.x).
Clear the Save as File check box on the Output Options sheet
in the Print dialog box.
An incorrect printer driver is selected. Make sure that the PostScript printer driver that you are using
to print is selected.
The Emulation Menu in the printer’s Control Panel is set
to a mode other than Auto or PS3 for the interface
that you are using.
Change the mode setting to either Auto or PS3.