User guide

M4000 Software
2-4 72A-1230 Rev. F
July 22, 2005
• Both LV leads must be inserted to run test: requires that both the
red and blue leads be inserted into the test set to run a test (rarely
used).
• Safety strobe is required to run test: In the event there is a failure of
the strobe bulb or cable, this should be disabled so as to be able to
continue testing without it.
• Safety switch must be released between tests: Serves to discourage
user from artificially holding safety switch down for the duration of
several tests.
• Restrict the Safety Configuration settings: If selected, serves to lock
the above 4 selections so that they cannot be changed from within the
application.
NOTE Use this last option with care, since if a need arises to change one of the above
settings (a burnt out strobe light bulb), you cannot change the settings and
continue testing without reinstalling the software.
9. A screen will appear where your company name, as you wish it to appear
in the Nameplate area, can be input. Leave it blank if you prefer to fill the
name in manually each time.
10. Finally, you will be asked which languages you wish to have installed on
the computer. You may choose English, French, Spanish, and Portuguese,
and different users may switch among them from the
Tools/Configure/Advanced menu.
Figure 2.4 Languages Installed
11. If using diskettes, insert subsequent disks when prompted and press the
ENTER key.
12. You will be asked if you wish to read the “readme” file.