Operating instructions

Operating Instructions Chapter 6
C4000 Standard/Advanced
8009861/WA65/2012-06-12 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 53
Subject to change without notice
Electrical installation
 For the connection of pin 9 and 10 only use cable with twisted cores, e.g. the SICK
connection cables available as accessories (see chapter 12.7 “Accessories” on
page 111).
 If you do not use EFI device communication, to improve the EMC behaviour we
recommend, especially on cascaded systems, the termination of the pin 9 and 10
connections (EFI device communication) on the system connection in the control
cabinet using a resistor of 182  (see section 12.7 “Accessories” on page 111).
6.2 Configuration connection M8× 4 (serial interface)

Pin  Sender/ Receiver PC-side RS@232-D@Sub
1 Not assigned
2 RxD Pin 3
3 0 V DC (voltage supply) Pin 5
4 TxD Pin 2
The pin assignment of sender and receiver is identical.
 After configuration always remove the connecting cable from the configuration connec-
tion!
 After the configuration of the device has been completed, locate the attached
protection cap to cover the configuration connection.
Notes
Fig.
33
:
Pin assignment
configuration connection
M8  × 4
Tab.
16
:
Pin assignment
configuration connection
M8  × 4
Notes
4
2
3
1