Specifications

24
CD-E800W
03/8/27 CD-E800W(A)3.fm
TINSE0908AWZZ
Tape Recording
Note:
Whilst recording, OPEN/CLOSE button is deactivated. It is recom-
mended to perform CD recording after closing the disc tray.
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
" Recording from the radio
To interrupt recording:
Press the REC PAUSE (TAPE-2 ) button.
To resume recording, press the same recording button you pressed
in step 5. Other buttons do not allow resuming.
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
" Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
" Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1
Tune in to the desired station. (See page 17.)
2
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button to choose
one side or both sides.
... To record on both sides.
... To record on only one side.
4
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
5
Press the ( ) button to record on side A, or the
[(TAPE-2) ] button for side B.
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette com-
partment. Insert a blank tape into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button
until "TAPE 1" appears on the
display.
The reverse mode will be set to " ".
4
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
5
Press the ( ) button to start dubbing.
1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
3 Set the button to " " to erase only one side and to " " to
erase both sides.
4 Press the REC PAUSE (TAPE-2 ) button.
5 Press the ( ) button to erase side A, or the [(TAPE-2) ]
button to erase side B.
To erase both sides, begin with side A. (If erasing is started from
side B, the tape will not switch over to side A.)
8