Specifications
23
CD-E800W
03/8/27 CD-E800W(A)3.fm
TINSE0908AWZZ
Tape Recording
Recording to a cassette tape
Before recording:
!
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
!
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
!
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
!
For recording, use only normal tapes. Do not use metal or
CrO tapes.
!
Recording can be operated in the TAPE 2 compartment. The
TAPE 1 is for playback only.
" Recording from a CD (CDs)
You can record 3 CDs continuously.
To perform programmed recording:
To stop recording:
Press the button.
The CD and tape will stop.
Erase-prevention tab of cassette tapes:
!
When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
!
To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
Side A
Tab for
side B
Tab for
side A
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the CD button and load the desired disc.
4
Press the button to choose
one side or both sides.
... To record on both sides.
... To record on only one side.
5
Press one of the 1 - 3 buttons on the remote control to
select the disc to be recorded first.
6
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
7
Press the ( ) button to record on side A, or the
[(TAPE-2) ] button for side B.
!
To record on both sides, begin with side A. (If recording is
started from side B, the tape will not switch over to side A.)
!
Recording is started from the selected CD. When the play-
back of the last disc is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
!
CD playback will start approximately 7 seconds after the tape
starts.
1 Programme discs and tracks. (See page 16.)
2 Press the REC PAUSE (TAPE-2 ) button.
3 Press the ( ) button to record on side A, or the [(TAPE-
2) ] button for side B.