Installation guide

MN-748
5
Finger tight only. Do not over tighten.
4. LOOSELY install the
3
/8” lock washer (N) and
3
/8 x
7
/8” hex head cap screws (M). Leave
loose to allow installation of the upper bracket.
5. Attach the lower bracket (C) to the bottom of the air spring. Use the forward, inboard
hole as shown in g. 4.
6. Secure lower bracket to the air spring using the
3
/8” lock washers (N) and
3
/8” x
7
/8” hex
head cap screws (M). Torque to 20 ft./lbs.
7. This completes the assembly of the Passenger side (g. 5). Now assemble the Driver
side (left hand) in the same manner.
NOTE
Driver Side
Passenger Side
Forward
g. 2
Short Threads into
the Air Spring
g. 5
g. 3
g. 4
Driver
Forward
Passenger
Use this hole
Use this hole
LoadLifter 5000