Installation guide

MN-748
9
Some late models are equipped with the RSC (roll stability control) system (g. 16). On
these models it will be necessary to loosen the axle vent tube bolt and rotate the brake
line junction box counter clockwise as far as it will let you. Tighten the axle vent tube bolt
securely (g. 17).
3. Secure the lower bracket to the axle using the saddle clamps (G), at washers (K) and
3/8” nuts (J). See g. 18.
4. Torque the nuts to 16 ft-lbs (g. 18). Trim excess bolt off if desired.
g. 15
NOTE
g. 17
g. 18
g. 16
Rotate Counter
Clockwise
Axle Vent
Tube Bolt
LoadLifter 5000