Service manual

70
Reassembly
KohlerEngines.com 62 690 01 Rev. C
Install Oil Cooler
1. Connect hoses between oil fi lter adapter and oil
cooler. Secure with new clamps.
2. Align oil cooler with bosses in backing shroud
assembly. Secure screws and washers to 2.2 N·m
(20 in. lb.).
Install Electric Starter
1. Install electric starter motor using screws.
2. Torque screws to 15.3 N·m (135 in. lb.).
3. Connect leads to solenoid.
Install Valley Baffl es
1. Install valley baffl es and secure with mounting
screws. Lower section should fi t under outer baffl e.
Torque M6 screws going into cylinder head to 10.7
N·m (95 in. lb.) for new holes, or 7.3 N·m (65 in. lb.)
for used holes. Start upper M6 screws only if main
control bracket rear supports attach to these screws.
2. Torque M6 screw going into lower blower housing
mounting clip to 2.5 N·m (22 in. lb.).
Install Carburetor
WARNING
Explosive Fuel can cause fi res and severe
burns.
Do not fi ll fuel tank while engine is hot or
running.
Gasoline is extremely fl ammable and its vapors can
explode if ignited. Store gasoline only in approved
containers, in well ventilated, unoccupied buildings,
away from sparks or fl ames. Spilled fuel could ignite
if it comes in contact with hot parts or sparks from
ignition. Never use gasoline as a cleaning agent.
1. Install a new carburetor gasket onto intake manifold
with tab up. Make sure all holes align and are open.
2. Attach choke return spring and bracket to front hole
in choke lever on carburetor.
3. Connect throttle and choke linkages to carburetor if
they were previously disconnected. Install carburetor
with linkages attached as an assembly.
4. Connect fuel line to carburetor inlet and secure with
a clamp.
Control Bracket Components
G
E
F
A
I
H
N
M
O
C
D
B
K
L
J
A Throttle Lever B Throttle Linkage C Nut D Governor Arm
E Governor Spring F Governed Idle Spring G Cross Shaft H Governor Lever
I Choke Cable Clamp J Control Pivot Pin K Pal Nut L Choke Linkage
M Choke Return Spring N Choke Bracket O Choke Lever