Service manual

ENWW Chapter 3 Operation 65
POWERSAVE TIME 1 MINUTE
15 MINUTES
*30 MINUTES
60 MINUTES
90 MINUTES
2 HOURS
4 HOURS
Sets how long the printer remains idle before it enters
PowerSave mode.
PowerSave mode does the following:
● minimizes the amount of power the printer consumes
when it is idle
● reduces wear on electronic components in the printer
(turns off the display backlight, but the display is still
readable)
The printer automatically comes out of PowerSave mode
when you send a print job, press a control-panel button,
open a tray, or open the top cover.
To turn PowerSave mode on and off, see “POWERSAVE” on
page 70.
DISPLAY
BRIGHTNESS
1
2
3
4
*5
6
7
8
9
10
Customizes the readability of the display panel for your
environment by lowering or raising brightness.
PERSONALITY *AUTO
PCL
PS
Selects the default printer language (personality). Possible
values are determined by which valid languages are
installed in the printer.
Normally, you should not change the printer language. If
you change it to a specific printer language, the printer will
not switch automatically from one language to another
unless specific software commands are sent to the printer.
CLEARABLE
WARNINGS
*JOB
ON
Sets the amount of time that a clearable warning is shown
on the control-panel display.
● JOB: The clearable warning message appears until the
end of the job that generated the message.
● ON: The clearable warning message appears until you
press (S
ELECT).
AUTO CONTINUE OFF
*ON
Determines how the printer reacts to errors. If the printer is
on a network, you probably want to turn
AUTO CONTINUE
to
ON.
● ON: If an error occurs that prevents printing, the
message appears on the control-panel display, and
the printer goes offline for 10 seconds before returning
online.
● OFF: If an error occurs that prevents printing, the
message remains on the control-panel display, and
the printer remains offline until you press
(S
ELECT).
Table 14. Configure device menu—system-setup submenu
Item Values Explanation