Service manual

190 Troubleshooting ENWW
TYPE MISMATCH
TRAY [XX]=[TYPE]
alternates with
Ready
For help press
The system detected a different
type of media from the type
specified for the tray in the paper
path coming from tray XX.
1 Verify that the correct media is
loaded in the tray.
2 Check the driver settings to
make sure that the expected
media type is selected.
3 Check the media-type settings
on the printer control panel to
make sure that the printer is set
for the media type that is in the
tray.
4 Refer to the printer software
online Help for more
information.
USE TRAY [XX]
[TYPE] [SIZE]
alternates with
To change press /
To continue press
The printer did not detect the type
and size of media requested. The
message shows the most likely type
and size available and the tray in
which they are available.
Press (Select button) to accept
the values in the message, or use
(Up button) and (Down
button) to scroll through the
available choices.
Wait for printer to
reinitialize
The printer is reinitializing in one of
the following situations:
● The user has changed the RAM
DISK settings before the printer
is automatically rebooted.
● The printer is auto power
cycling after changing external
device modes.
● The user has exited
Diagnostics.
No action necessary.
Warming up The printer is coming out of
Powersave mode. Printing
continues as soon as the printer has
warmed up.
No action necessary.
10.XX.YY SUPPLIES MEMORY
ERROR
For help press
An error has occurred in one or
more of the printer’s supplies.
Values of XX and YY are listed
below:
XX
00 = memory is defective
01 = memory is missing
YY
00 = black print cartridge
1 Turn the printer power off, and
then turn the printer power on
to clear the message.
2 If the message persists,
contact an HP-authorized
service or support provider
(see “Ordering parts and
supplies and getting support”
on page 242).
Message Description Recommended action