Service manual

ENWW Chapter 6 Removal and replacement 175

Feed belts

1 Remove all of the covers and the control-panel assembly (see pages 113 through 124).

2 Remove the laser/scanner plate (page 144).

3 Use a flatblade screwdriver to pry the left end of the paper feed shaft (callout 1) out of the

printer.

4 Slide the paper-feed shaft to the left to disengage the right end of the shaft.

5 When the paper-feed shaft is free from its position in the printer, lift the pulleys (callout 2) and

slide the feed belts off of the paper-feed shaft.

Note After removing the feed belts, the pulleys can fall out of the printer. Make sure that you don’t lose

any of the pulleys.

Figure 100. Removing the feed belts