Service manual

162 Removal and replacement ENWW

Power supply

1 Remove the following covers and assemblies:

• I/O cover (see page 113)

• DIMM cover (page 115)

• rear cover (page 116)

• front cover (page 119)

• control panel (page 120)

• top cover assembly (page 121)

• formatter (page 147)

• drive assembly (page 148)

• access plate (page 159)

2 Remove two screws (callout 1) from the media guide and then lift the media guide off of the

bottom plate.

Figure 87. Removing the power supply (1 of 6)