Service manual

ENWW Chapter 6 Removal and replacement 143
Laser/scanner
1 Remove all of the covers and the control-panel assembly (see pages 113 through 124).
2 Unplug one cable connector (callout 1) from the engine controller PCA.
3 Unplug the flat, flexible cable (callout 2) from the laser/scanner.
4 Remove four screws (callout 3).
Figure 68. Removing the laser/scanner
5 Lift the laser/scanner off of the laser/scanner plate.
Reinstall note
Reattaching the flat, flexible cable to the laser/scanner before reseating the laser/scanner might
be easier than reattaching it afterwards.
2
2
2
3
2
1