Service manual

120 Removal and replacement ENWW

Control panel

1 Remove the following covers

• I/O cover (see page 113)

• DIMM cover (page 115)

• rear cover (page 116)

• front cover (page 119)

2 Remove three screws (callout 1) from the control panel.

3 Disconnect one connector (callout 2).

Figure 45. Removing the control panel

4 Lift the control panel away from the printer.

Reinstall note

Make sure that the connector shown in callout 2 in figure 45 is reconnected correctly. If, after

reassembly, the control panel malfunctions, unplug this connector and then reconnect it.