User Manual

(Continued)
Sleep operation
The radio, compact disc and cassette deck can all be turned off
automatically.
1 Play back the desired sound source.
2 Press the TIMER/SLEEP button repeatedly until "SLEEP" is
displayed.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME (
X
or
W
) button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during the sleep
operation.
3 hours - 5 minutes 5-minute intervals
5 minutes - 1 minute 1-minute intervals
3 Press the MEMORY/SET button.
4 The unit will enter the stand-by mode automatically after the
preset sleep time has elapsed.
Note:
Once the sleep time is set, it will remain the same duration
until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by mode.
USING EXTERNAL UNITS
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1 Use a separately available RCA lead to connect the desired
external unit to the VIDEO/AUX sockets.
(red right channel, white left channel)
When using video equipment (Laser Disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the VIDEO/AUX button.
4 Operate the external unit.
5 To record the sound from the external unit, perform steps 2
- 5 of the "Recording from the built-in radio" section on page
20.
Note:
To prevent hum interference, do not place this unit near a
television receiver.
TIMER/
SLEEP
MEMORY/
SET
TUNING/
TIME
( )
2
3
(Main unit operation)
To the line output socket
RCA
lead
E-22