Specifications

HK
<P=001>
RECORDING
● When recording important selections, be sure to
make a preliminary test to ensure that the desired
material is being properly recorded.
● The volume and sound quality can be adjusted with
no effect on the recorded signals (Variable Sound
Monitor).
● Metal and CrO2 tapes should not be used for recording or
dubbing.
■ Recording from the built-in CD player
(CD Synchronised Recording System)
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CD button and load the desired disc.
● Use the APMS function to store the tracks you want to record
in memory. (See page 15.)
3 Load a cassette into the TAPE 2 cassette compartment.
● Load the tape with side A (1) facing you.
● Wind past the leader of the tape, on which recording can not
be performed.
4 Press the button.
... To record on only one side.
... To record on both sides.
5 Press the REC PAUSE (● ) button.
● "SYNC" and "REC" will flash.
6 Press the ( ) button to record on side A (1), or the
button to record on side B (2).
● "SYNC" will disappear and "REC" will light up.
● CD playback will start approximately 5 seconds after the tape
starts.
● To record on both sides, begin on side A (1). [If recording is
started from side B (2), the tape will not switch over to side
A (1).]
To stop recording:
Press the ■ button.
The CD and tape will stop.
Auto restart function:
● When recording continuously on both sides of the
tape:
1
2
345
1
2
3
45
CD
TAPE
A
B
Even if the last track of side A (1) is not finished recording, side
B (2) will automatically start recording from the beginning of that
track.
The recording will be made without cutting the beginning of the
track on side B (2).
TAPE 2
PUSH
EJECT
1
2
6
5
6
4
3
5
1
6
2
6
CD-80W(SCOT) TINSZ0637AWZZ
E-19
Downloaded from www.Manualslib.com manuals search engine
Downloaded From Disc-Player.com Sharp Manuals