Operation Manual, User's Manual

5-5
SCANNER►SCANNER SEQUENCE
SENDING AN IMAGE
BASIC TRANSMISSION PROCEDURE
Using the document feeder
Scanner transmission job cannot be accepted while printing a fax receiving data. Start scanning after the fax data printing is
finished.
1
Make sure the machine is in scan mode.
When the SCAN indicator is lit, the machine is in scan mode. If the indicator is not lit, press the [SCAN] key ( ).
If auditing mode has been enabled for the scan function in the system settings, a message will appear prompting you to
enter your account number when you switch to scan mode. Enter your account number (five digits) with the numeric
keys.
► User Authentication
(page 6-12)
2
Place the original.
Place the original in the document feeder tray of the
automatic document feeder.
► AUTOMATIC DOCUMENT FEEDER
(page 1-31)
3
Check the original size.
To change the original size, change as explained in STORING SCANNING SETTINGS (page 5-12).
4
If needed, select the resolution setting.
► SELECTING THE RESOLUTION (page 5-13)
The initial factory setting is [200dpi].
5
If needed, select the format.
► SELECTING THE FILE FORMAT (page 5-14)
The initial factory setting
• Colour / Greyscale : PDF M
• B/W : PDF G4
6
If needed, select "Mono/Grey".
► SELECTING THE Mono2/Greyscale (page 5-14)
7
Press the [ADDRESS] key ( ).