Operation Manual, User's Manual

4-39
FACSIMILE►CONVENIENT FAX FUNCTIONS
Chain Dialling
To set an auto-dial number as a Chain Dial number, complete Editing and deleting auto-dial numbers (page 4-42).
Transmission speed setting
To set the transmission speed, complete Editing and deleting auto-dial numbers (page 4-42).
About the setting options
When storing and editing and Speed Dial numbers, you can also select the setting options below. Chain dialling cannot
be combined with any of the other setting options.
When you select a setting option, a checkmark appears in the setting option screen.
• Chain Dialling......................................You can enable or disable Chain Dialling for a Rapid key or Speed Dial
number. (►page 4-39)
• Transmission speed............................You can set the transmission speed to 33,600 bps (maximum speed), 14,400
bps (high speed), 9600 bps (middle speed), or 4800 bps (low speed). The initial
setting is 33,600 bps (maximum speed). (►page 4-39)
• International transmission mode .........The international transmission mode can be set to "Off" or one of modes 1 to 3.
The initial setting is "Off". (►page 4-40)
When a number is set as a Chain Dial number, the destination fax number can be up to 48 digits long.
1
Select "Chain Dial" with the [ ] or [ ] key and press the
[OK] key.
• If checkmark appears to the left of "Chain Dial", it is already selected.
• To exit, press the [B/W START] key.
2
Select "On" or "Off" with the [ ] or [ ] key.
Set the transmission speed only when you know what speed is most suitable, such as when you are sending a fax to a
foreign country and telephone line conditions are bad. If you do not know the line conditions, do not change this setting.
1
Select "TX Speed" with the [ ] or [ ] key and press the [OK] key.
2
Select the desired transmission speed with the [ ] or [ ] key.