User's Manual

5
TOLL FREE: 1-877-646-5288
Fig. 3b
Fig. 2
Fig. 1
Assembly and Use for the 72 oz. Pitcher
CAUTION: Blade assemblies are sharp, not locked
in place and removable, handle with care. When
handling the blade assemblies, always hold them
by the shaft.
IMPORTANT: Make sure that the motor base is plugged
in for use.
1 Place the motor base on a clean, dry, level surface such
as a counter or table top.
2 Align and lower the pitcher onto the motor base. (Fig. 1)
Handle should be aligned slightly to the right of the “LOCK”
symbol on the motor base.
3 Rotate the pitcher clockwise as far as it will go to lock in
place. (Fig. 2)
4 The pitcher can be placed on the motor base two ways;
the handle can be on the front right corner or the front
left corner. (Fig. 3a, Fig. 3b)
5 Holding the Stacked Blade Assembly by the top of the
shaft, place it onto the drive gear inside the pitcher.
Ensure that the blade assembly is seated properly and is
standing upright. (Fig. 4)
NOTE: The Stacked Blade Assembly will fit loosely on the
drive gear.
6 Add the ingredients to the pitcher, making sure that they
do not exceed the highest measured marking line on the
side of the pitcher.
7 Holding the lid by the handle in the upright position, place
it on top of the pitcher aligning the arrow ( ) located on
the lid with the arrow ( ) located on the pitcher’s handle.
(Fig. 5) Press the handle down until you hear a click.
8 Plug the power cord into the electrical outlet and press
the power button ( ).
NOTE: As a safety feature, the power button
( ) will flash and the motor will not work if the
pitcher and lid are not installed correctly. When
the pitcher and lid are installed properly, the
power button ( ) will be solid, indicating that the
appliance is ready for use.
Fig. 4
Fig. 5
Assembly
Fig. 3a