Manual

SETTINGS
10 During the data checking, "Checking" blinks. 12 When the software is successfully updated, a
screen is displayed indicating that the update
process is completed.
o If the update has failed, check the file in the USB
device and try Software Update again.
NOTE
If the update of the AUDIO section starts automatically
after the software update, the STANDBY indicator will blink.
version of the update file on the USB memory device When the update is completed, the STANDBY indicator
are displayed. To update this system software with stops blinking and lights up. (The power will be turned off
update file, select "Yes", and press ENTER. automatically.) Never disconnect the AC power cord until
this status is reached.
The current version of this unit software and the
13 If prompted by a displayed message to turn off
the system, press POWER to turn it off.
14 Remove the USB memory device.
o Deleteunneeded softwareupdate data using a PC
afterthe software update process iscompleted.
Ifthe USB memory device is not properly installed or
the correct update file cannot be found on the USB
memory device, an error message is displayed.
Check the file on the USB memory device, and then
reinsert the USB memory device correctly.
1 1 Press ENTER to start updating.
The screen becomes dark for a while until the update
screen can be displayed. Please wait for the update
screen to appear. Do not unplug the AC cord.
_- 78
!