Owner's Manual
POWER
Troubleshooting
Other
Problem
Possible causes and solutions
The
1V
operates incorrectly.
• Some 1Vs with wireless remote control capability may operate incorrectly when
using the remote control
of
this
Player.
Use such 1Vs away from this
Player.
The Player heats up during use.
• When using this
Player,
the console cabinet may heat up depending on the usage
environment. This
is
not a malfunction.
ON/STANDBY indicator
will
remain • When the AC cord
is
removed from the outlet, the ON/STANDBY indicator will
lit.
remain
lit
for a short period. This
is
normal and
is
not a malfunction.
To
Reset this Player
•
If
this Player receives strong interference from a source such as excessive static electricity,
strong external noise, malfunction
of
power supply,
or
voltage caused by lightning during
use or a wrong operation
is
sent to the
Playei',
errors like the Player
nOl
accepting
em
operation may occur.
Press and hold
POWER on
theJ=:~er
uGtil
''2
E 5
EJ~~pears
of1,lt1illr9.DlJ2illteLgjs..Q~
when the
PlaYf:2L90eS
not
OQillalsLQroQec)Ye\,ien
after
Jb~
QQ'yVer
tlg~
QilliD..mrned,QfL Then,
after the ON/STANDBY indicator
is
lit,
turn on the power.
• When a reset
is
performed while the power
is
on, the Player will turn off.
Turn
the power on again. At this point,
it
may take
a few moments for the system processing to finish before the Player
is
ready for use. During the system processing, the
BD/DVD/CD mode indicator on the front panel displAy of the Player will blink. Once the system processing has finished, the
indicator will finish blinking and then light up normally.
You
can operate the Player when the BD/DVD/CD mode indicator
is
lit.
• Since
all
settings including the language setting stored
in
memory are also reset when a reset has been performed, they must
be set again.
• When the problem persists even after performing a reset, unplug the AC cord and plug
it
in
again.
If
this does not solve the
problem, contact the nearest service center approved by
SHARP.
On-screen Error Messages
The following messages appear on the
1V
screen
in
case
of
an
error during operation.
Error message
Possible Error Suggested Solution
Cannot
play.
• The disc cannot be played back with
• Check the disc, and load it correctly.
this
Player.
Incompatible disc.
•
If
you load a disc which cannot
be
played with this Player
(i.e.
a scratched
disc), or
if
you load a disc upside down,
this message will appear, and the disc
tray will automatically pop out.
• Occurs
if
the loaded disc cannot be
• Remove the disc.
played because it
is
a non-standard disc
or
scratched, etc.
Cannot operate.
• Occurs
if
an
operation
is
incorrect.
This USB memory
is
not formatted
• Occurs if there
is
a formatting
error.
• Format the USB memory again.
properly. Please format the memory
in
• Occurs if the USB memory
is
not
• Format the USB memory with your
USB memory management. formatted with
FAT
32/16. PC.
The Connected USB Memory cannot
• Occurs
if
USB memory not compliant • Connect USB 2.0 High Speed
be used.
It
should
be
compliant with with USB 2.0 High Speed (480Mbit/s)
is
(480Mbit/s) compliant USB memory.
USB 2.0 used
(i.e.
USB 1.O/USB 1.1).
@-
54