Owner's Manual

Troubleshooting
Picture (Continued)
Problem
Possible causes and solutions
Screen freezes and operation
•
Turn off the power and turn on the power again.
buttons do not work.
•
If the power is not turned off, perform a reset. (Page 54)
•
Is the disc damaged or dirty? Check the condition of the disc. (Page 9)
There is just audio with no video.
•
Is the connection cable for video output connected properly? (Pages 14-16)
Widescreen video appears vertically
•
Is "TV Aspect RatiO" set to match the connected TV? (Page 39)
stretched, or black bands appear at
• If you are using a widescreen
TV, is the "TV Aspect Ratio" set to "Wide"? (Page 39)
the top and bottom of the screen.
Square noise (mosaic) appears on
• Blocks
in images may be visible in scenes with rapid movement due to the
the screen.
characteristics of digital image compression technology.
The playback screen will be
• This Player complies with analog copy protection. Some discs contain a
copy
disturbed if DVD video is recorded
prohibiting signal.
if you try to play back such discs through a VCR, or record to a
to a VCR, or played back through a
VCR and play back the signal. the copy protection will prevent normal playback.
VCR.
(Pages 15-16)
Audio is not output, or images are
• The audio may not be output or the images may not be played back properly for
not played back properly.
some discs
in which copyright-protected contents are recorded.
Sound
Problem
Possible causes and solutions
No sound. or sound is distorted.
•
If the volume of the TV or amplifier is set to minimum, turn the volume up.
• There
is no sound during still mode. slow motion playback, fast forward and fast
reverse. (Pages
32-33)
• DVD audio recorded in DTS is only output from the DIGITAL AUDIO OUT terminal.
Connect a
DTS compatible digital amplifier or decoder to the DIGITAL AUDIO OUT
OPTICAL terminal on this Player. (Page 17)
• Check that the audio cable is connected correctly. (Page 17)
• Check that the cable plugs are clean.
•
Take out the disc and clean it. (Page 9)
• Audio may not be output depending on the audio recording status. such as when
audio other than
an audio signal or non-standard audio is recorded for the audio
content of the disc. (Page
6)
Left and right channels of audio are
• Are left and right audio cables connected to the opposite terminal, or
is one side
reversed, or sound comes out of disconnected? (Page 17)
only one side.
Audio is not output, or images are
• The audio may not be output or the images may not be played back properly for
not played back properly. some discs
in which copyright-protected contents are recorded.
Network
Problem Possible causes and solutions
Cannot connect to the Internet.
•
Is the LAN cable connected properly?
•
Is the wrong cable such as a modular cable used? Connect a LAN cable to the
ETHERNET terminal. (Page 18)
•
Is the power for the connected equipment, such as broadband router or modem
turned on?
•
Is the broadband router and/or modem properly connected?
•
Is the proper value(s) set in the network setting? Check "Communication Setup"
(Pages
42-44)
Cannot download SO· LIVE contents.
•
Is the LAN cable connected properly?
•
Is the USB memory device properly connected? Check that the USB memory
device
is connected to the BD STORAGE/SERViCE terminal of this Player.
• Check if the BD disc suppol1s BD-L1VE.
• Check the setting for "SO Internet Access' (Page 41)
•
»
'0
'0
<D
:::3
a.
)ii'
(Continued on the next page)
@- 53