Manual

ManualsBrandsSharp ManualsBlu-Ray PlayersBD-HP21U

Troubleshooting

Left and right channels of audio are reversed, or

sound comes out of only one side.

,, Are left and right audiocablesconnectedto the opposite

terminal,or is oneside disconnected?

Disc does not play back automatically.

• Have you set a disc that has an automatic playback

function?

The Player heats up during use.

• When using this Player, the console cabinet may heat

up depending on the usage environment. This is not a

malfunction.

The Player makes a snapping sound when

starting playback or loading a disc,

" The player may sometimes make a snapping sound when

starting playback if it has not been operated in a while.

These sounds are not malfunctions of the player but are

normal operating conditions.

Cannot operate the Player.

• Are you operating the Player within the specified operating

temperature range? (Page 45)

STANDBY indicator will remain lit.

• When the AC cord is removed from the outlet, the

STANDBY indicator will remain lit for a short period. This is

normal and is not a malfunction.

NOTE

Reset

,, Ifthis Player receives strong interference from a source such as

excessive static electricky, slrong external noise, malfunction

of power supply, or voltage caused by lightning during use or a

wrong operation is sent to the Player, errors like the Player not

accepting an operation may occur. Press and hold POWER on the

Hayer until "_ _ S _ L" appears on the front panel display when the

Player does not operate properly even after the power has been

turned off. Then, after the STANDBY indicator is lit, turn on the

power.

,, When a reset isperformed while the power ison, the Hayer will

turn off. °lurn the power on again. At this point, it may take a few

moments for the system processing to finish before the Player

is ready for use. During the system processing, the BD/DVD/CD

mode indicator on the front panel display of the Player will blink.

Once the system processing has finished, the indicators will finish

blinking and then light up normally. You can operate the Player

when the BD/DVD/CD mode indicator is lit.

,, Since all settings including the language setting stored in memory

are also reset when a reset has been performed, they musl be set

again.

,, When the problem persists even after performing a reset, unplug

the AC cord and plug it inagain. IIthis does not solve the problem,

contact the nearest service center approved by SHARR

On-screen Error Messages

Messages Relating to BD and DVD

= The following messages appear on the TV screen in case the disc you tried to playback is not appropriate or the

operation is not correct.

Error message

CANNOT PLAY.

INCOMPAHBLE DISC.

Possible Error

,, The disc cannot be played back with this Player.

,, If you load a disc which cannot be played with

this Player (i.e. a scratched disc), or if you load a

disc upside down, this message will appear, and

the disc tray will automatically pop out.

,, Occurs if the loaded disc cannot be played

because it is a non--standard disc or scratched,

etc.