Manual

SETTINGS
5 Press A/V/_/_ to select the speaker, then 7 Repeat steps 5 and 6 until each speaker's size,
press ENTER. and level are set.
6
Press 4/_ to select the preferred item, then
press A/V to select the preferred setting, then
press ENTER.
NOTE
" The speakers L and R, LS and RS move relative to one another.
,, The speakers L and R are automatically set to "LARGE" when the
subwoofer SW is set to "NO", even after speakers L and/or R are
set to "SMALL".
,, The images of speakers set to "NONE" disappear or are greyed
out on the screen.
,, As for a subwoofer, there are no settings for distance only for level.
8 Press A/T/4/_ to select "TEST START", then
press ENTER.
L/R LARGE*, SMALL
C/RS/LS LARGE*, SMALL, NONE
SW YES*, NO
* Factory preset
LARGE: The cone diameter is 6.3 inches or larger.
SMALL: The cone diameter is smaller than 6.3 inches.
lft through 29ft
(Settings available in lft increments)
The factory preset value: 12ft(L/R/C)
6ft(RS/LS)
6dB through +6dB
(Settings available in ldB increments)
The factory preset value is 0dB.
After switching to TEST mode, you can hear the Test
sound from each speaker in turn.
If you press A/T/_II/_ to select the preferred
speaker while the TEST sound is present, you
can hear the TEST sound of the speaker that you
selected.
If you press _,/Y/_II/_ to select "TEST TONE
STOP" and press ENTER, you can stop the Test
sound
(_) =38