Specifications

1. lgnmon coil 3. Orange
‘2 Red/whore 4. Electra tester
c. Connect fully charged battery to tester.
d
2.
Turn on spark gap switch and increase gap
until misfire occurs.
111
Direct current resistance test.
Use a pocket tester
meter to determine
tinuity of primary
windings.
or equivalent
ohm-
resistance and con-
and secondary coil
---
0
-0
Standard values:
Primary coil resistance:
3.9s2 t 10% at 20°C
Secondary coil resistance:
8Kn * 20% at 20°C
E. Condenser test
If the contact points show excessive wear, or
the spark is weak (but the ignition coil is in
good condition), check the condenser.
1. Capacity test (use Electro Tester).
a. Calibrate capacity scale.
b. Connect tester.
c. Meter needle will deflect and return to
center as condenser is charged. After
needle stops, note reading on
“p F” scale.
2.
a.
b.
Condenser capacity:
0.22/.1F 2 10%
Insulation test.
Connect ohmmeter as shown
(n x 1,000
or more).
Resistance reading should be
m or at lease
3MR. If less, replace.
2
Condenser
Battery
After this measurement, the condenser
tive lead wire to the condenser case.
1. Primary coil resistance value
4.
Redlwhne
2. Secondary coil resistance value
5.
Orange
3. Ignition coil
6. Ohmmeter
&? x 1)
- 55
Property of www.SmallEngineDiscount.com - Not for Resale