Specifications

Part to be tightened
Brake disc and hub
Caliper and support bracket
Caliper and pad
Caliper and bleed screw
Front caliper and front fork
Master cylinder and cylinder bracket
Pivot shaft
Rear wheel axle
Tension bar and brake caliper (plate)
Tension bar and rear arm
I
Thread dia. and part name
!
Tightening torque
8 mm bolt 2.0 m-kg (14.5 ft-lb)
1
8 mm bolt
1.8 m-kg (13.0 ft-lb)
5 mm bolt
0.3 m-kg
( 2.2 ft-lb)
8 mm bolt 0.6 m-kg (( 4.5 ft-lb)
10 mm bolt 3.5 m-kg (25.5 ft-lb)
6 mm bolt 0.6 m-kg
( 4.5 ft-lb)
14 mm nut 6.5 m-kg (47.0 ft-lb)
16 mm nut 15.0 m-kg (108.5 ft-lb)
8 mm nut 1.8 m-kg (13.0 ft-lb)
8 mm nut
3.2 m-kg (23.0 ft-lb)
Rear shock absorber Upper
10 mm bolt
Rear shock absorber Lower 10 mm bolt
Rear arm and rear arm end 8 mm bolt
Front fender
8 mm bolt
Neutral switch
I 12mm
3.0 m-kg (21.5 ft-lb)
3.9 m-kg (28.0 ft-lb)
1.0
m-kg (7.2 ft-lb)
1.0 m-kg ( 7.2 ft-lb)
1.3 m-kg ( 9.5 ft-lb)
General Torque Specifications tighten multi-fastener assemblies in a criss-
This chart specifies torque for standard cross fashion, in progressive stages, until full
fasteners with standard I.S.O. pitch threads. torque is reached. Unless otherwise specified,
Torque specifications for special components torque specifications call for clean, dry
or assemblies are included in the applicable threads. Components should be at room
sections of this book.
To avoid
warpage, temperature.
r
A
(Nut)
IOmm
12mm
14 mm
17mm
B
(Bolt)
6mm
8mm
10mm
12mm
Standard tightening torque
m-kg ft-lb
0.6
4.5
1.5
11
3.0
22
5.5
40
19mm
14 mm
8.5
61
22 mm
16mm
13.0
94
-24-
Property of www.SmallEngineDiscount.com - Not for Resale