Specifications

Part to be tightened
Thread dia. and pan name
1 Tightening torque
Brake disc and hub B mm bolt
i 2.0 m-kg (14.5 ft.lb1
Caliper and support bracket 8 mm bolt
~ 1.8 m-kg 113.0 ft.lbi
Caliper and pad
I
5 mm bolt
0.3 m-kg I 2.2 ft-lb1
Caliper and bleed screw 8 mm bolt
0.6 m-kg
( 4.5 ft-lb)
Front caliper and front fork 10 mm bolt
3.5 m-kg (25.5 ft-lb)
Master cylinder and cylinder bracket
:
6 mm bolt
0.6 m-kg
I 4.5 ft-lb)
Pivot shaft
14 mm nut
6.5 m-kg (47.0 ft-lb)
Rear wheel axle 16 mm nut
115.0 m-kg (108.5 ft-lb)
Tension bar and brake caliper (plate)
!
8 mm nut
1.8 m-kg (13.0 ft-lb)
Tension bar and rear arm B mm nut
i 3.2 m-kg (23.0 R-lb1
Rear shock absorber
Upper
Rear shock absorber
Lower
Rear arm and rear arm end
Front fender
Neutral switch
10 mm bolt
: 3.0 m-kg (21.5 ft-lb1
~
10 mm bolt
i 3.3 m-kg (28.0 ti-lb1
- 8 mm bolt
I 1.0 m~kg I 7.2 ti-lb1
~ 8mm bolt ~~-~~~~~??~~# ~~’
12mm
General Torque Specifications
tighten multi-fastener assemblies in a criss-
This chart specifies torque for standard
cross fashion, in progressive stages, until full
fasteners with standard I.S.O.
pitch threads.
torque is reached. Unless otherwise specified,
Torque specifications for special components
torque specifications call for clean, dry
or assemblies are included in the
applicable
threads.
Components should be at room
sections this
book. To avoid warpage,
temperature.
Property of www.SmallEngineDiscount.com - Not for Resale