Specifications

e. Inspect the starter plunger assembly for
damage. If damaged, replace.
f. Float level
Hold the carburetor in an upside down
position. Hold the floats so the tang is
just touching the float needle. Measure
the distance from the top of the float to
the float bowl gasket base surface
without the gasket. If the distance is out
of the specification, correct the specifi-
cation.
Float level: 27.3 f 0.5 mm
(1.075 * 0.02 in)
To correct, carefully bend the tang on
the float arm. Both floats must be at the
same height.
I
Float height
26.8-27.8mm
(1.055 - 1.095 in1
1
1
- 169-
Property of www.SmallEngineDiscount.com - Not for Resale