Specifications
Tightening torque:
1.5 m-kg (1.1 ft-lb)
2.
a.
b.
Aluminium wheels
Always inspect the aluminium wheels
before riding. Place the machine on the
center stand and check for cracks, bends
or warapage of the wheels. Do not at-
tempt even small repairs to the wheel. It
must be replaced.
Tires and wheels should be balanced
whenever either one is changed or re
placed. Failure to have a wheel assembly
balanced can result in poor perfo-
rmance, adverse handling character-
istics, 
and shortened tire life.
Tire pressure 
(XS650SF/XS650-2F)
To insure maximum performance and long
service, note the following:
1. Always maintain proper air pressure as
described in the chart. Check tire pres-
sure daily, before riding, and adjust as
necessary.
‘XS65OSF
Only
“XS650-2F
only
BASIC WEIGHT
Nith
 oil and full
l 
102 kg (226  
lb) 
‘118 kg (260 lb
fuel
 tank “100 kg 
(221
lb)
 l 
*116 kg (256 lb
Bridgestone
 or
Bridgestone
 or
standard
 tire 
Yokohama 
Yokohama
3.5OS194PR
13OBOS184PR
vlsximum
 load limit 
166 kg I365 
lb) 
279 kg 
(615
lb1
Zold
tire
presswe:
UP to 90 kg 
1.6 
kg/cm2 
2.0 
kg/cm=
(198 
lb)
 load
(22
psi
1
(28
psi1
9Okg1198Ib)load
5
 206 kg (453 lb)
load (Maximum
2.0 
kg/cm2 
2.3 
kg/cm2
(28
 psi 
I
132
Psi)
load)
High 
speed
 riding 
2.0 
kg/cm2 
2.3 
kg/cm2
(28
psi) 
132 
psi)
Minimum 
tire
wad
 depth
0.8 mm (0.03 
in)
 0.8 mm (0.03 in)
2. Before operation, always check the tire
surfaces for wear and/or damage; for
example: cracks, glass, nails, metal
fragments, stones, etc. Correct any such
hazard before riding. If a tire tread
shows crosswise lines, it means that the
tire is worn to its limit. Reolace the tire.
G. Drive chain
1.
 Tension check
NOTE:
Before checking and/or adjusting, rotate
rear 
wheel
 through several revolutions and
check tension several times to find the
tightest point. 
Check and/or adjust chain
tension with rear wheel in this “tight chain”
position.
Inspect the drive chain with both tires
touching the ground and without rider.
Check the tension at the position shown
in the illustration, The normal vertical
. . 
20-30
 mm 
(0.8-
 1.2 in)
-
140-
Property of www.SmallEngineDiscount.com - Not for Resale










