SHARP RADIO CONTROLLED WIRELESS THERMO CLOCK Instruction Manual & Warranty P178318GB010
Thank you for your purchase of this quality Wireless Thermo Clock. The utmost care has gone into the design and manufacture of your clock. Please read these instructions carefully and store them in a safe place for future reference. The Wireless Thermo Clock has a clear, easy-to-read display that shows the time, month, date, day of the week, indoor temperature and outdoor temperature. The Wireless 915 MHz technology a l l o w s y o u t o place the sensor anywhere you like.
4. TIME BUTTON: - In normal time mode, press it to enter alarmi and alarm2 time mode. - Press and hold it for 2 seconds to enter the normal time setting mode. - In normal time setting mode, press it to step the setting items. 5. UP BUTTON: - In normal time mode, press it to switch between M-D (Month-Date) and D-M (Date-Month) formats. - In alarm time mode, press it to select the proper time zone. - In time setting mode, press it to increase the setting values.
13. WALL-MOUNTING HOLE: - Use it to support the main unit when hanging clock. 14. TABLE STAND: - Use it to stand the clock on the desktop. 15. BATTERY COMPARTMEMT AND DOOR: - Accomodates 2 AA size batteries. TRANSMITTER 5. BATTERY DOOR 6. WALL-MOUNTING HOLDER: - Use it to support the transmitter on the wall. 7. TABLE STAND: - Use it to stand the transmitter on the desktop. SETTING UP THE TRANSMITTER: 1.
NOTE: 1. 2. To receive the transmitter signal, the channels of receiver and transmitter must be synchronized. Once the channel is assigned to a transmitter, you can only change it by removing the batteries or resetting the unit. SIGNAL STRENGTH INDICATOR The signal indicator displays signal strength in 4 levels. Wave segment flashing means time signals are being received.
4. 5. TIME ZONE SETTING 6. Press the “UP” or “DOWN” button to change its value. Repeat the above operations (point 3, 4) to set the below items in this order: Date > Hour > Minute > Second > Day Language > +/-23 hours time difference. Press the “TIME” button to save and exit the setting mode, or let it exit automatically 30 seconds later without pressing any key. The default time zone is PACIFIC. If your location is not in the Pacific, set the time zone as follows: NOTE: 1. 1. 2. 3.
3. 4. 5. 6. Press the “UP” or “DOWN” button to change its value. Press the “ALM ON/OFF” key once until the alarm Minute digit flashes. Press the “UP” or “DOWN” button to change its value. Press the “ALM ON/OFF” button to save and exit the setting mode, or let it exit automatically 30 seconds later without pressing any key. 2. The alarm will be automatically turned on when you set the alarm time.
2. 3. Relocate the clock or transmitter in other positions and make sure the transmission is within the effective range of 30 meters approx. After several trials in vain, please reset the clock thoroughly. Try out where your multifunctional alarm clock receives the signals best. While if the low battery indicator displays beside the indoor temperature, it means that the battery power of the main unit is not enough and you should replace batteries in the clock immediately.
SPECIFICATIONS MAIN UNIT Recommended operating range: 0°Cto45‘’C or 32 “F to 113 “F Resolution: O.rC (above -9.9'’C) rc (below -10“C) 0.rF(-9.9°F~99.9‘’F) 1°F (above 100°F& below -10'’F) REMOTE SENSOR Recommended operating range: -20°Cto55‘’C or -4”Fto131°F Resoiution: 0.rC/”F (above-9.9”C/°F) rC/'F (below-10°C/“F) RF transmission frequency: 915 MHz No. of remote unit: up to 2 units RF transmission range: 330 feet (100 meters) Radio controiled signai: WWVB POWER Main unit: 3V. use2xAA1.
TWO YEAR LIMITED WARRANTY M.Z. Berger & Company warrants the original consumer purchaser of this product that it shall be free of defects in materials and workmanship for two years from the purchase date of this product. Defects caused by tampering, improper use, unauthorized modifications or repairs, immersion in water or abuse are not covered by this warranty. If a defect covered by this warranty occurs during the warranty period, wrap your clock carefully and send it to the following address; M.Z.
