Service manual

AR-203E/5420/M200/M201 FIRMWARE DOWNLOAD PROCEDURES 14 - 5

7) PC side: Double-click "Special (MCU/IMC2/Facsimile)" to

develop its sub trees, and select "Upload EEPROM Data

Area" in the sub trees.

8) PC side: Enter a desired file name, and select "Save."

9) PC side: When upload is completed, the complete message is

displayed.

With the above procedure, the EEPROM data acquisition is com-

pleted.

Data acquired by the EEPROM data acquisition procedure are

saved in a file with extension of .eep.

5. Installing procedures

Driver installation is made on plug-and-play.

1) Main unit side: Execute simulation No. 49-01 (Flash ROM pro-

gram write mode).

Check that "d" is displayed (or "DOWNLOAD MODE" is dis-

played for the AR-M200/M201) on the operation panel. (Press

and hold [Clear] key and [ZOOM DOWN] key ( ) (or

[ZOOM]/[COPY RATIO] key for the AR-M200/M201) together,

and turn on the power simultaneously.)

2) Connect the machine and the PC with a USB cable.

3) The [Found New Hardware] display is shown as below. Select

[Locate and install driver software (recommended)].

Note: A message to confirm the administrator of the computer is

displayed. Press [Agree] button.

4) The [Found New Hardware - DOWNLOAD] display is shown.

Click [I don't have the disc. Show me other options.].