Service manual

[3] SETUP
1. Parts list
Before installing the printer kit, check that all the following items are prepared.
Be careful that the necessary parts depend on the environment of the copier (model and unit installation).
Part name Model Q’ty Note
Accessories SCSI cable 1
Wire saddle 1
Band 1
Printer box installing screw 5
Printer control PWB 1 With frame
Printer driver Printer Driver (including PPD File) 1
Screen Font 1
Resident-FontData Install Utility 1
Printer Administration Utility ver.2.x 1
NWsetup 1
Printer Status Monitor ver.2.0 1
Integrated Installer 1
Makedisk Utility 1
Installation manual 1
Operation Manual 1
Label 1 Only for Sweden and Norway
Option Expansion board AR-EB1 1 The expansion board is necessary to
install the printer kit to the AR-S280.
SIMM memory 16MB ED0 type/Without parity/70ns or above
The copier ICU PWB requires the total
memory of 16MB(20MB) or more.
The printer control PWB has two
expansion slots to which 16MB or 32MB
memory can be additionally installed.
(16MB onboard)
32MB
Network card AR-NC3D 1 10Base-T / 100Base-TX
Separate purchase
(User purchase)
Printer (parallel) cable Necessary when the copier is used as a
stand-alone machine.
2. Preliminary work
If the version of the three kinds of flash memory installed to the copier
is older than the following, upgrade is required.
Check version number, and perform the upgrade if necessary. (For
the procedure, refer to the Technical Report.)
3. Hardware setup
A. Common work
(1) Printer unit installation
1) Turn "OFF" the main switch located on the left-hand side on the
main copier unit.
Next, unplug the power plug of the main copier unit from the
outlet.
2) Removing the rear cover of the main copier unit.
If equipped with the RADF/ADF/SPF, loosen the securing screws
which the hold the RADF/ADF/SPF connector and remove the
connector from the main copier unit.
If the rear cabinet is a box type, remove the connector cover in
advance.
Remove the five securing screws which hold the rear cover of
main copier unit, then remove the rear cover.
Next, loosen the upper central one of four securing screws which
hold the rear lower cover, then remove the rest three screws, and
then remove the rear lower cover.
"OFF"
Main switch
Screw
Connector
Rear cover
Rear
cover
Rear
lower cover
Securing
screw
Securing
screw
Securing screws
Loosen
Rear
lower cover
Securing screws
Loosen
Connector
cover
• If the rear cabinet is a box type:
AR-PB2A
3 – 1