Service manual

AR-P17 SETTING AND ADJUSTMENTS 4 - 3
D. Function cancel display
• When the diag menu or the key operator program menu is displayed,
the current machine state (the key is canceled or not) is displayed.
• Display content
ON: The function lock is working.
OFF: The function lock is canceled.
• Regardless of the display position
4. Key operator program list
Key operator programs Set value (∗: Default value) Remarks
Print settings
Default settings Prohibit notice page printing ON / OFF∗
Print density level 1 / 2 / 3∗ / 4 / 5
Prohibit test page printing ON / OFF∗
Rotated print ON∗ / OFF
Forced output of print ON / OFF∗
Exclude bypass-tray from ATS ON∗ / OFF
Disable default setting changes ON / OFF∗
Interface settings Hexadecimal dump mode ON / OFF∗
I/O timeout 1 – 999 (Increment of 1sec.) 60 (sec.)∗
Parallel port emulation switching Auto∗ / PostScript (When the PS3
expansion kit is installed.) / PCL
USB port emulation switching Auto∗ / PostScript (When the PS3
expansion kit is installed.) / PCL
Network port emulation switching Auto∗ / PostScript (When the PS3
expansion kit is installed.) / PCL
Port switching method Switch at end of job∗ / Switch after I/O
timeout
Enable parallel port ON∗ / OFF
Enable USB port ON∗ / OFF
Enable network port ON∗ / OFF
Enable ECP ON / OFF∗
Network settings
(When the print server
card installed.)
IP address
setting
DHCP
ON∗ / OFF To enable the changed setup, the
power must be rebooted.
*1) Displayed when the AR-NC5J is
installed. Not displayed when only
the AR-P17 is installed.
IP address
ON∗ / OFF
IP subnet mask
ON∗ / OFF
IP gate way ON∗ / OFF
Enable TCP/IP *
1)
ON∗ / OFF
Enable NetWare *
1)
ON∗ / OFF
Enable EtherTalk *
1)
ON∗ / OFF
Enable NetBEUI *
1)
ON∗ / OFF
Reset the NIC —
Initialise and/or store
settings
Restore factory default —
Store current configuration —
Restore configuration
—
To enable the changed setup, the
power must be rebooted.