Service manual

AR-M208 EXTERNAL VIEW AND INTERNAL STRUCTURE 6 - 1

[6] EXTERNAL VIEW AND INTERNAL STRUCTURE

1. External view

∗

Dehumidification heater switch (DH POWER)

This copier is equipped with a dehumidification heater, which prevents

dew condensation inside the copier and moisture absorption of paper

in the paper trays. If dew condensation occurs and causes moisture

absorption of paper, image quality may be deteriorated and paper mis-

feeds may occur frequently. It is recommended that the dehumidifica-

tion heater switch be left in the “ON” position in the following cases

even after the power switch is turned off.

• In a low temperature season such as winter (When a sudden tem-

perature change occurs, for example, immediately after room heat-

ing is turned on, dew condensation may occur.)

• In a high temperature and high humidity season such as summer or

rainy season (Depends on the use conditions. The reference is 60%

(humidity) or more.)

• In regions at a high temperature and a high humidity

NOTES:

• When using the dehumidification heater, do not remove the power

cord from the outlet. Doing so will stop the heater.

• If an optional 500-sheet paper feed unit or 2x500-sheet paper feed

unit is installed, the heater in the unit will also be turned on when the

dehumidification heater switch of the copier is turned on.

No. Name Function/Operation

RSPF Duplex documents are automatically reversed to perform continuous copying of the front and the

back.

2 Paper output tray Finished copies are deposited in the paper output tray.

3 Front cover Open to remove misfeeds and for copier servicing.

4 Paper trays Each tray holds 500 sheets of copy paper.

5 Dehumidification heater switch

∗

Press to turn on the heater to prevent dew condensation inside the copier and moisture absorption

of paper.

6 Power switch Press to turn copier power on and off.

7 Handles Use to move the copier.

8 Operation panel All copier controls are located here for easy operation.

9 Original table Place the document to be copied here.

10 Upper exit area cover Open to remove misfeeds when an optional job separator tray kit or finisher is installed.

11 Side cover Open to remove misfeeds.

12 Side cover handle Lift and pull to open the side cover.

13 Bypass tray guides Adjust to the width of the copy paper.

14 Bypass tray Special papers (including transparency film) and copy paper can be fed from the bypass tray.

15 Bypass tray extension Pull out when feeding large paper such as 8-1/2" x 14" and 11" x 17".