Owner's Manual

9
KEY OPERATOR PROGRAMS
FUNCTION SETTING
The programs of this category are used to adjust various settings of copier functions. These programs
can be selected by using the and keys to highlight "FUNCTION SETTING", pressing the OK key,
highlighting the desired program, and then pressing the OK key.
Key Operator Number Change
See page 2, REGISTERING THE KEY OPERATOR CODE NUMBER.
Exposure Adjust
Use this program to lighten or darken copies in the automatic exposure mode. The exposure level can
be set for copying from the platen glass or copying from either a RSPF. The factory setting is level 3.
When "EXPOSURE ADJUST" is selected and the OK key is pressed, the following display will appear.
1. Use the and keys to select the "PLATEN" (platen glass) or "RSPF".
2. Adjust the exposure using the and keys.
3. Repeat steps 1 and 2 to adjust the other exposure level.
4. Press the OK key.
Margin Default
Set the initial margin shift value with this program.
When "MARGIN DEFAULT" is selected and the OK key is pressed, the following display will appear.
1. Adjust the initial margin shift value using the and keys.
●
The value can be set from 1/4" to 1" in 1/4" increments.
2. Press the OK key.
EXPOSURE ADJUST
PLATEN
RSPF
MARGIN DEFAULT
1
/ 4 inch
(1/4~1)
Ar-M208_keyope_sec.book 9 ページ ２００２年６月１２日 水曜日 午後３時４１分