Specifications

AR-FX8 SIMULATIONS, FAX SOFTWARE SWITCH 6-50
104 1 Pseudo-nighttime mode
setting <When iFAX
receive setting is made>
Used to set whether the minimum low power consumption mode is set or not
when the right power switch is turned off. However, this function is valid only
when iFAX receive setting is made.
0 Enters the
pseudo-
nighttime
mode.
2-8 Not used 0
0
0
0
0
0
0
105 1-8 Not used 0
0
0
0
0
0
0
0
106 1-4 The number of resend in
iFAX communication
error (Setting in NG in
serve check request
respond)
Used to set the number of resend in NG of serve check respond in iFAX send
with serve check request. The setting range is 0 - 15 times by binary input.
When set to "0," no resend is made.
0Twice
0
1
0
5 iFAX date, sender’s
name print language
select <Format>
Used to set the date and sender’s name format in iFAX send. 0 Follows the
date format.
6-8 Not used 0
0
1
107 1,2 iFAX paper exit tray
setting
Used to set the paper exit tray of iFAX receive data. (When the finisher is
installed.)
0
0
3-5 Not used 0
0
0
6 Report output (receive
reject) <iFAX only>
Used to set whether the communication report is outputted or not in "Receive
reject" of iFAX receive. However, this function is valid only when the report
output (in iFAX receive) is set to "Not print."
0 Not output
7 Not used 0
8 Switch from the image
send display to the copy
display
Used to set whether the image send display is switched to the copy display or
not.
1Switch
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
1: Not enter the pseudo-
nighttime mode.
(Enters the nighttime
mode.)
0: Enters the pseudo-
nighttime mode.
(Not enter the
nighttime mode.)
1: North America format 0: Follows the date
format.
Bit No.
With finisher
installed +
auto
1 1:Finisher tray 0:Center tray
With finisher
installed +
manual offset
2 1:Finisher
lower tray
0:Finisher
upper tray
1: Output 0: Not output
1: Switch 0: Not switch
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 50 ページ ２００３年１１月１２日 水曜日 午前９時４５分