Specifications

AR-FX8 SIMULATIONS, FAX SOFTWARE SWITCH 6-40
46 7,8 V.8 mode ANSam signal
send time
Used to set ANSam signal send time when sending ANSam signal in V.8 mode. 0 4sec
1
47 1-8 Not used 1
0
0
1
0
0
1
1
48 1-8 Not used 0
1
0
0
0
0
1
0
49 1-8 Dial number in tone
pulse auto setting
Used to set dial number (2 digits) in auto setting of telephone kind (DP/DTMF).
Setting is made by BCD input.
The set range is 0 ~ B. When set to outside the set range, the default value of 5
is applied to.
055
1
0
1
0
1
0
1
50 1-6 Not used 0
0
0
0
0
0
7 Setup of send/receive
complete sound
(buzzer length)
Used to set the buzzer length from the speaker made after completion of FAX
transmission and reception. Excluding when a communication error occurs.
0 1sec
8 Not used 0
51 1 Voice answering send
level to the line
Used to set the voice answering volume to the line. Set to Large or Small with
the hardware.
0 Large
2-7 Not used 1
0
0
0
0
0
8 Line monitor range Used to set the line monitor range when the line monitor function is used.
When set to "Until NSF signal send/receive," monitoring is made until DCS or
NSF signal is received. When set to "All," all are monitored until the line is
disconnected.
0Until NSF
signal send/
receive
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
Bit No. 7 8
3sec 0 0
4sec 0 1
5sec 1 0
6sec 1 1
1: 3sec 0: 1sec
1: Small 0: Large
1: All 0: Until sending/receiving NSF signal
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 40 ページ ２００３年１１月１２日 水曜日 午前９時４５分