Specifications

AR-FX8 SIMULATIONS, FAX SOFTWARE SWITCH 6-33
24 5 Simplified ACR function 0 Function
OFF
6 CED signal send Used to set whether CED signal is sent or not.
Valid only when SW43.1 (V.34 mode function ) is OFF.
This is because ANSam signal is indispensable in V.34 mode.
0 Send
7,8 CED signal send time Used to set the time for CED signal send.
ANSam signal follows SW46-7 ~ 8.
0 3sec
0
25 1,2 CED/ANSam send start
wait time
Used to set the wait time for sending CED/ANSam signals to the line from FAX
reception state after connection of the line.
0 2.25sec
0
3,4 CNG send time Used to set the wait time from connection of the line to sending of CNG signal
to the line.
1 2sec
1
5 CED detection time Used to set the wait time for determination of the signal when detecting CED/
ANSam signal.
0 500ms
6-8 Not used 0
0
0
26 1,2 Number of times of RCP
send
Used to set the number of times of RCP send when sending Phase C in ECM
system.
When the other party cannot detect the RCP frame, it becomes easy to detect
RCP.
03 times
0
3 Number of RTC EOL
send
Used to set how many EOL's are sent as RTC when sending Phase C.
When the other party cannot detect the RCP, it becomes easy to detect RCP.
06 times
4-8 Not used 0
0
0
0
0
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
1: Function ON 0: Function OFF
1:CED signal is not sent. 0:CED signal is sent.
Bit No. 7 8
3sec 0 0
4sec 0 1
5sec 1 0
6sec 1 1
Bit No. 1 2
2.25sec 0 0
3sec 0 1
4sec 1 0
2.25sec 1 1
Bit No. 3 4
0.5sec 0 0
1sec 0 1
1.5sec 1 0
2.0sec 1 1
1: 1000ms 0: 500ms
Bit No. 1 2
3 times 0 0
6 times 0 1
9 times 1 0
12 times 1 1
1: 12 times 0: 6 times
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 33 ページ ２００３年１１月１２日 水曜日 午前９時４５分