Specifications

AR-FX8 SIMULATIONS, FAX SOFTWARE SWITCH 6-32
21 1-3 Setup of call time in auto
transmission
(T0 timer setup)
Used to set the time (sec) of calling when the other party does not receive the
call in automatic transmission.
The set range is 30 - 75sec in the increment of 15sec by binary input of N into
"(15sec x N) + 30sec." The set range of N is 0 ~ 7. When set to a value outside
the set range, the initial value of the destination is applied to.
0 45sec Send setup
0
1
4-7 T1 timer setup Used to set the time (sec) for connection of line when the other party does not
respond in FAX communication.
The set range is 30 - 105sec in the increment of 5sec by binary input of N into
"(5sec x N) + 30sec." N is set in the range of 0 - 15. T1 timer is the timer for the
time from recognition of FAX CED or DCS) by the other party after connection
of line. The ITU-T standard is 35 ± 5sec.
0 40sec
0
1
0
8 Not used 0
22 1-4 Not used 0
0
0
0
5,6 T4 timer setup at auto
mode
(+1.5sec for manual)
Used to set the timer up to respond and receive.
Timer for DCS signal to respond and receive.
For the ITU-T standard, 3sec ± 15%.
0 3sec
0
7,8 Not used 0
0
23 1 EOL detection timer Used to set the detection timer (sec) of EOL (End Of Line) in Phase C reception
of G3 mode.
If an error occurs in EOL detection, it is processed as EOL not detected.
0 13sec
2-6 Not used 0
0
0
0
1
7,8 RTN send line error rate Used to set the threshold value for judgment of RTN sending in G3 reception.
The threshold value is of STD conversion. The half of this value is used for
judgment of RTP sending.
When, for example, FINE is received, the threshold value is doubled.
1 60 lines
0
24 1 DCS-TCF interval time Used to set the time interval (sec) from DCS sending to TCF signal sending.
The ITU-T standard is 75 ± 20ms.
0 75msec
2 EQM judgment
threshold value
when confirming TCF
reception
Used to set whether the threshold value (FTT) is set severely or loosely for
EQM judgment in confirmation of TCF reception.
If set loosely, TCF is easy to return CFR, but apt to cause an error in PIX
(Phase C).
0 Severely
3 Judgment method in
confirmation of TCF
reception
Used to set the judgment method of FTT in confirmation of TCF reception. 0 0
4 Not used 0
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
Bit No. 5 6
3sec 0 0
4sec 0 1
5sec 1 0
6sec 1 1
1: 25sec 0: 13sec
Bit No. 7 8
6 liens 0 0
12 lines 0 1
60 lines 1 0
120 lines 1 1
1: 150msec 0: 75msec
1: Loosely 0: Severely
1: Judged by EQM
value. TCF is
checked loosely.
0: Received data is judged to
be 0 or not, and EQM value
is judged.
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 32 ページ ２００３年１１月１２日 水曜日 午前９時４５分