Specifications

AR-FX8 UNPACKING AND INSTALLATION 5-4
14) Clear the image memory.
* If an extended memory (AR-MM9) has been mounted in step 3), be
sure to carry out this step.
If no extended memory has been mounted, this step is not
necessary.
<1>Switch the operation panel to the copy mode and use the key
operation [P], [*], [C], and [*] to enter the simulation mode.
<2>Use the 10-key pad to enter "66" in the main code entry screen
shown below and press the START key.
<3>Use the 10-key pad to enter "10" in the sub-code entry screen shown
below and press the START key.
<4>Use the 10-key pad to enter "1" in the submenu screen shown below
and press the START key.
<5>The screen shown below is displayed and memory clear operation is
executed.
<6>After several minutes, memory clear operation is completed and then
the main unit is rebooted automatically.
15) Connect the line cable to the FAX box unit.
Connect the line cable to the FAX box unit.
Line cable
[05]UNPACKINGANDINSTALLATION.fm 4 ページ ２００３年１１月１２日 水曜日 午前９時４５分