Service manual

AR-FX7 SIMULATION 6 - 10
Operation/Procedure
1. Select the item with the 10-key, and press the [START] key.
2. Enter the set value with the 10-key.
The sending dial cannot be interrupted.
3. Select the soft SW reflection.
Note: Executable only when the FAX is installed.
Operation/procedure
Enter the DTFM signal (1 digit (1 to 9, 0, *, #)) and press the [START]
key.
When the [CUSTOM SETTINGS] key is pressed during execution, the
simulation is terminated.
Note: Executable only when the FAX is installed.
Operation/Procedure
Enter the DTFM signal (1 digit (1 to 9, 0, *, #)) and press the [START]
key.
When the [CUSTOM SETTINGS] key is pressed during execution, the
simulation is terminated.
Note: Executable only when the FAX is installed.
Operation/Procedure
Select "1: YES" with the 10-key, and press the [START] key. The data
are backed up. (When "2: NO" is selected, the simulation is canceled.)
* The AR-FX5 data cannot be written into the AR-FX7. If it is exe-
cuted, data are initialized and deleted. In addition, the AR-FX7 data
cannot be used in the AR-FX5.
Note: Executable only when the FAX is installed.
Operation/Procedure
Select "1: YES" with the 10-key, and press the [START] key. The Flash
ROM data are read out and written into the SRAM. (When "2: NO" is
selected, the simulation is canceled.)
* The AR-FX5 data cannot be written into the AR-FX7. If it is exe-
cuted, data are initialized and deleted. In addition, the AR-FX7 data
cannot be used in the AR-FX5.
Note: Executable only when the FAX is installed.
Operation/procedure
1. Select the item to be printed.
2. Press the [START] key.
The information of the selected item is printed.
66-16
Purpose Operation check/test
Function
(Purpose)
Used to perform the dial test. (DTFM signal send test)
Section FAX
Item Operation
Item Content
Setting
range
0 EXECUTE Execution –
1 HIGH (SW) High group 0-15
2 HIGH-LOW (SW) High group, Low group 0-15
Item Content
1 NO STORE TO SW Not reflected.
2 STORE TO SW Reflected. (Shift SW value changed.)
66-17
Purpose Operation check/test
Function
(Purpose)
Used to check the DTFM signal send operation.
(Signal send level: Max.)
Section FAX
Item Operation
66-18
Purpose Operation check/test
Function
(Purpose)
Used to check the DTFM signal send operation.
(Signal send level: Set by soft SW.)
Section FAX
Item Operation
1
1
66-19
Purpose Back up
Function
(Purpose)
Used to write the SRAM data to the Flash ROM.
Section FAX
Item Data
66-20
Purpose Back up
Function
(Purpose)
Used to write the Flash ROM data to the SRAM.
Section FAX
Item Data
66-21
Purpose Check
Function (Purpose) FAX information print
Section FAX
Item Data
Item Content
1 USER SW.LIST User setting list
2 SOFT SW.LIST Soft SW list
3 SYSTEM ERROR System error list
Used to print the system error log (error
number and time).