Service manual

AR-FX7 INSTALLATION PROCEDURE 3 - 2
5) Attach the TEL/LIU PWB.
Insert the connector of the TEL/LIU PWB to the connector of the
FAX PWB, fit two spacers to the TEL/LIU PWB, and attach the
TEL/LIU PWB using two M3 screws with washer.
6) Reattach the left rear cabinet.
<1> Pass the speaker harness through the hole of the frame of the fax
expansion PWB and connect it to the connector of the fax PWB.
<2> Fit the pawls of the left rear cabinet to the mounting portions of
the main unit. Slide the cabinet toward the front of the main unit to
attach it.
<3> Secure the left rear cabinet using two screws.
<4> Attach the supplied fax connector cover.
<Step for mounting extended memory (AR-MM9)>
If you need not to mount an extended memory, proceed to step 8.
7) Mount an additional memory (AR-MM9)
Insert the additional memory into the socket on the FAX PWB.
8) Reattach the shielding plate.
Fit the pawls of the shielding plate to the main unit and secure the
plate using five screws.
Insert the power plug of the copier to the outlet and turn
on the main switch. Then, carry out the following
procedure.
9) Paste the label on the left rear cabinet of the copier.
Paste the FCC label to the position shown in the illustration.
10) Clear the image memory.
* If an extended memory (AR-MM9) has been mounted in step 7, be
sure to carry out this step.
If no extended memory has been mounted, this step is not neces-
sary.
<1> [P], [*], [C], and [*] to enter the simulation mode.
<2> Use the 10-key pad to enter “66” in the main code entry screen
shown below and press the START key.
<3> Use the 10-key pad to enter “10” in the sub-code entry screen
shown below.
TEL/LIU PWB
M3 Screws with washer
Spacers
Speaker harness
Screws
Left rear cabinet
Fax connector cover
Pawls
Screw
In order to manifest the compliance with FCC Part 68 and IC CS-03,
it is required to provide the machine with the FCC Registration Num-
ber (USA), Ringer Equivalence (USA) and Ringer Equivalence (Can-
ada).
After installing the FAX expansion kit in the machine, please put the
registration label, packed with the kit, on the prescribed location.
Screws
Shielding plate
FCC label