Specifications

AR-FX5 UNPACKING AND INSTALLATION 5-1
[5] UNPACKING AND INSTALLATION
<Before installation>
•For installation of AR-FX5, an MFP control PWB unit and a scanner unit
must have been installed.
•Start installation after checking that the communication indicator on the
operation panel is not lit or blinking.
1) Turn the main switch of the printer to OFF.
Turn the main switch located on the front of the printer to OFF.
Then, remove the power plug of the printer from the outlet.
2) Remove the MFP control PWB unit.
<1>Remove the scanner cable from the printer.
<2>Remove the two screws that secure the MFP control PWB unit to the
printer.
Then, hold the two grips and pull out the MFP control PWB unit to
remove it from the printer.
3) Remove the FAX interface cover.
Remove the two screws that secure the FAX interface cover of the
MFP control PWB unit and remove the FAX interface cover.
•If you need not mount an extended memory, proceed to step 5).
4) Mount an extended memory.
Mount an extended memory to the socket on the front surface of the
FAX interface PWB unit.
5) Attach the FAX interface PWB unit.
Connect the FAX interface PWB unit to the FAX interface PWB
connector (100 pins) of the MFP control PWB unit and secure the
unit with two screws C.
Parts included
FAX interface PWB unit
(1 pc.)
FAX interface cable
(1 pc.)
Line cable
(1 pc.)
Screw A
(1 pc.)
Screw B (large)
(2 pcs.)
Screw C (small)
(2 pcs.)
OFF
Scanner cable
Grip
Screw
Screw
Grip
Step in case of mounting extended memory (AR-MM9)
Screw
FAX interface
cover
Extended memory
FAX interface PWB unit
FAX interface
PWB unit
Screws C