Specifications

AR-FX5 MACHINE OPERATION 7-3
4. Own number sending
This function prints the date, time, your programmed name, your
programmed fax number, and the transmitted page number at the top
center of each page that you fax. All pages that you fax include this
information.
Example of fax page printed out by the receiving machine
<1> Date and time : programmed in the custom settings.
<2> Own name : programmed with the key operator
program.
<3> Own fax number : programmed with the key operator
program.
<4> Transmitted page number : 3-digit number appearing in the format,
"page number/total pages"
(only the page number appears if you
use manual transmission or Quick On-
Line transmission).
If desired, you can use the key operator
program to omit the page number.
A. Position of sender's information
The key operator program can be used to select whether the sender's
information is added outside the original data or inside the data. The
initial factory setting is outside the data.
(1) Outside scanned data
None of the transmitted image is cut off; however, the transmitted data is
longer than the scanned data, and thus when both the sender and the
receiver use the same size of paper, the printed fax may either be
reduced or split up and printed on two pages.
(2) Inside scanned data
The top edge of the scanned data will be cut off by the sender's
information; however, when both the sender and the receiver use the
same size of paper, the printed fax will neither be reduced nor split up
and printed on two pages.
* May vary depending on the setup on the receiver side.
5. Quick On-line
When you use the auto document feeder to send a multi-page document
and there are no previously stored jobs waiting or in progress (and the
line is not being used), the machine dials the destination after the first
page is scanned and begins transmitting scanned pages while the
remaining pages are being scanned. This transmission method is called
Quick On-line. The messages SCANNING ORIGINAL and SENDING
both appear until scanning of the final page is completed.
If the receiving party is busy, the transmission will switch to a memory
transmission.
NOTE :
•The machine is initially set (factory setting) to perform Quick On-line
transmission. If desired, you can turn off this function with the key
operator program.
•When a document is transmitted using the following methods, the job
will be stored in memory (Quick On-line transmission will not be
performed):
<1>Sending from the document glass
<2>Broadcast transmission
<3>Timer transmission
<4>F-code transmission
MAY-11-2001-FRI 03:00 PM SHARP PLANNING DIV. FAX No. 0666211221 P. 001/001
<1> <2> <3> <4>
Direction of transmission
Length of
scanned data
Length of
transmitted data
Direction of transmission
Length of
scanned data
Length of
transmitted data