Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-46
71 1,2 Not used 0
0
3 Busy tone detection Used to set whether the busy tone signal is detected or not during automatic
dialing or ringing of pseudo-call of an external telephone.
0 Detected
4,5 Busy tone detection
cycle
Used to set the number of pulses for judgment of busy tone signal detection. 0 2 pulses
0
6,7 DT/BT detection level Used to set the minimum detection level for judgment of dial tone and busy tone
detection. If a signal level is lower than this setup, it is ignored.
0 -43dB
0
8 SDT signal detection Used to set whether SDT signal which is the second dial tone when transmitting to
F net is detected or not. When SDT signal is not detected, normal dialing is
performed after dialing of "16X."
0Not
detected
72 1,2 Lower limit of busy tone
detection time
Used to set the lower limit of detection time of busy tone signal frequency. To count
a busy tone signal as 1 pulse, it must be detected for more than the set time.
0 250ms
0
3 Upper limit of busy tone
detection time
Used to set the upper limit of detection time of busy tone signal frequency. To count
a busy tone signal as 1 pulse, it must be detected for less than the set time.
0 750ms
4,5 Frequency range setup
for detection of DT/BT
Used to set the frequency setup for detection of dial tone and busy tone. The
frequency range differs depending on the destination.
111
1
6-8 Not used 0
0
0
73 1-8 Not used 0
1
0
1
0
1
1
0
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
1: Busy tone is not detected. 0: Busy tone is detected.
Bit No. 4 5
2Pulse 0 0
4Pulse 0 1
6Pulse 1 0
10Pulse 1 1
Bit No. 6 7
-43dB 0 0
-35dB 0 1
-33dB 1 0
-30dB 1 1
1: Detected 0: Not detected
Bit No. 1 2
250ms 0 0
150ms 0 1
250ms 1 0
350ms 1 1
1:650ms 0:750ms
Bit No. 4 5
Modem fixed (Japan) 0 0
420Hz - 680Hz 0 1
360Hz - 440Hz(Australia) 1 0
245Hz - 650Hz(North America, U.K., Germany, France) 1 1