Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-43
56 1-7 Not used 0
1
0
0
0
0
0
8 Resend when no
response from the other
party
Used to set whether recall is made by judging no response of the other party as an
error in transmission. No response of the other party is caused when dial is
completed and the other party is a telephone.
0 Recall
57 1-4 Recall interval in
communication error or
line busy
Used to set recall interval when a communication error occurs or the line is busy.
The set range is 0 - 15min in the increment of 1min by binary input.
When 0 is selected, it is set to "3min."
0 3min Send setup
0
1
1
5-8 Number of times of
recall in communication
error
Used to set the number of times of recall when a communication error occurs in
transmission. The set range is 0 - 15 times by binary input. When 0 is selected, it is
set to the default (once).The limitation of the set range depends on the destination.
North America, Australia : Once only U.K., Germany, France: 1 ~ 5
0 Once Send setup
0
0
1
58 1-4 Number of times of
recall in busy
Used to set the number of times of recall when the other party's line is busy or the
other party does not receive. The set range is 1 - 15 times of 1min by binary input.
When 0 is selected, it is set to the default (2 times).
North America : 1 ~ 14, Australia ,U.K., Germany, France : 1 ~ 9
0 2times Send setup
0
1
0
5-8 Not used 0
0
0
0
59 1 Setup of reference of
the number of times of
recall in an error
Used to select the reference of the number of times of recall to an error or to line
busy when a communication error occurs in transmission.
1 Error Send setup
2 Recall allow in busy Used to set whether recall is made or not when the other party is busy or does not
receive in transmission.
1 Recall Send setup
3 Recall allow in
communication error
Used to set whether recall is made or not when a communication error occurs in
transmission.
1 Recall Send setup
4-8 Not used 0
0
0
0
0
60 1-8 Interval from the
completion of
communication to the
next call
Used to set the interval from the completion of communication to the next call.
The set range is 1 - 255sec by binary input. When 0 is selected, it is set to the
default (10sec).
0 10sec
0
0
0
1
0
1
0
61 1-8 Not used 0
0
0
0
1
0
0
0
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
1: Not recall 0: Recall
1: Refer to the number of times of recall
(SW57-5-8) in an communication error.
0: Refer to the number of times of
recall (SW58-1-4) in busy.
1: Recall 0: Not recall
1: Recall 0: Not recall