Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-39
47 1-8 Not used 1
0
0
1
0
0
1
1
48 1-8 Not used 0
1
0
0
0
0
1
0
49 1-8 Dial number when
automatic setup of tone
pulse
Used to set the dial number (2 digits) in automatic setup of telephone line kind (DP/
DTMF). The set range is 0 - B. If set to outside the range, it is set to the default, 5.
055
1
0
1
0
1
0
1
50 1-6 Not used 0
0
0
0
0
0
7 Setup of send/receive
complete sound
(buzzer length)
Used to set the buzzer length from the speaker made after completion of FAX
transmission and reception. Excluding when a communication error occurs.
0 1sec
8 Not used 0
51 1 Voice answering send
level to the line
Used to set the voice answering volume to the line. Set to Large or Small with the
hardware.
0 Large
2,3 Voice answering send in
automatic switch of FAX/
TEL
<Japan Only>
Used to set whether voice answering is sent before calling an external telephone or
after completion of calling an external telephone in automatic switch of FAX/TEL.
110
0
4-7 Not used 0
0
0
0
8 Line monitor range Used to set the line monitor range when the line monitor function is used.
When set to "Until NSF signal send/receive," monitoring is made until DCS or NSF
signal is received. When set to "All," all are monitored until the line is disconnected.
0Until NSF
signal send/
receive
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
Bit No 1234 5678
0101 0101
2nd
digit
1st
digit
1: 3sec 0: 1sec
1: Small 0: Large
Bit No. 2 3
Voice signal is not sent. 0 0
After external telephone call, "We are off at present. For facsimile message," 01
Before external calling, "Wait for a moment. For facsimile message," 1 0
Before external telephone call, "Wait for a moment." 1 1
1: All 0: Until sending/receiving NSF signal